Venturer PVS1680 Owner's Manual download pdf (Page 10)

GB - 9

INSTALLATION

Turning on the unit

1. Set POWER ON/STANDBY switch to POWER ON.

2. Set the DVD/AV IN switch to select the desired function.

• If you select DVD the DVD logo (start-up picture) will appear on unit screen.

Viewing Angle Adjustment

The unit is designed to allow users to have a comfortable viewing angle.

The viewing angle can be adjusted as top -12°~ +12°.

• Push screen frame to adjust viewing angle.

Caution:

• Do not force the screen frame over its maximum viewing angle settings

as stated above. Attempting this will result in damaging the unit.

Wall Mounting

1. Mark the correct mounting position on the wall, use attached the

template sheet for wall mounting.

2. Insert a fixing screw(s) at the marked position on the wall.

3. Align the slot hole(s) of the unit over the screw and pull the unit

downward until it is firmly hooked.

Installing the unit onto the seat back in a car

The unit is designed to allow users to install onto the seat back by supply straps.

1. Connect the short strap latch into upper or center ring, and long strap latch into lower ring on the back of unit.

2. Take short strap around the headrest of the driver's seat, then connect the latch to other side ring.

3. Take long strap around the lower of driver's seat, then connect the latch to other side ring.

4. Adjust the straps tightly so that the unit is secured.

PUSH INTO

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Venturer PVS1680 Owner's Manual Page 10